Waiting for you to follow us in these SNS, thank you. 
0086-17322110281
info@moldclamps.net

DGMF MOLD CLAMPS CO., LTD
·

Complete Specifications

Adequate Inventory

Factory Outlet

Fast Delivery

Quality Assurance

Competitive Price

Customizable

Our Mold Clamps Make Your Machines More Efficient And Durable, Lower Maintenance Costs!

Request for Inquiry
MOLD CLAMPS
+
+
NEWS    PRODUCTS
DGMF MOLD CLAMPS CO., LTD

Dynamic news
How to install a punching mold?
Original: | Author: dgmfmoldclamps | Publish Time: 2020-03-21 | 12507 Views | Share:
How to install a punching mold?

3) The lower mold should be completely fixed, and the upper mold should be fixed gently beforehand.

4) The slider on the punch presses for 20-30 trials. After confirming that the upper and lower dies are completely in a consistent state, tighten the upper dies.

5) The bite component of the punch and die of the punch is combined with the lower die stop of the die to adjust the height of the slider on the punch.

6) Use the test punch of the joint paper to confirm the cutting condition. If it is not uniform, check the installation status of the mold again. If the consistency is still not achieved, it is necessary to confirm the parallelism of the punch slider and the lower table of the punch.

7) Adjust the material feed length and feed time. (If a scrap cutter is attached, the length of the material can be checked by cutting the length of the scrap)

8) Comprehensive operation for 3-5 minutes. During this period, fill the oil between the guide post and the bushing, and confirm whether there is any abnormality in heat.