Waiting for you to follow us in these SNS, thank you. 
0086-17322110281
info@moldclamps.net

DGMF MOLD CLAMPS CO., LTD
·

Complete Specifications

Adequate Inventory

Factory Outlet

Fast Delivery

Quality Assurance

Competitive Price

Customizable

Our Mold Clamps Make Your Machines More Efficient And Durable, Lower Maintenance Costs!

Request for Inquiry
MOLD CLAMPS
+
+
NEWS    PRODUCTS
DGMF MOLD CLAMPS CO., LTD

Dynamic news
How to install a punching mold?
Original: | Author: dgmfmoldclamps | Publish Time: 2020-03-21 | 12504 Views | Share:
How to install a punching mold?

4.8 The mold pressing plate horn must be higher than the part pressed by the mold, and the diagonal locking method should be used.

4.8 When adjusting the mold, set the transfer switch to the inching position.

4.9 After the mold is installed, turn the stroke switch to the "adjust" position and gradually adjust the stroke depth.

4.10 After the die is adjusted, start the switch to test the punch.

4.11 In the production of the die, after the first trial stamping is qualified, explain to the operator the matters needing attention during normal production.

4.12 After normal work, the machine and mold running conditions should be checked at any time. If problems are found, they should be reported for repair immediately. How to install a punch mold

1) Check whether the blanking holes of the mold and the blanking holes of the pad are consistent.

2) After the upper and lower dies are assembled, place them on the lower table surface. The reference plane of the punch and the reference plane of the mold must be parallel.