Waiting for you to follow us in these SNS, thank you. 
0086-17322110281
info@moldclamps.net

DGMF MOLD CLAMPS CO., LTD
·

Complete Specifications

Adequate Inventory

Factory Outlet

Fast Delivery

Quality Assurance

Competitive Price

Customizable

Our Mold Clamps Make Your Machines More Efficient And Durable, Lower Maintenance Costs!

Request for Inquiry
MOLD CLAMPS
+
+
NEWS    PRODUCTS
DGMF MOLD CLAMPS CO., LTD

Dynamic news
How to install a punching mold?
Original: | Author: dgmfmoldclamps | Publish Time: 2020-03-21 | 9597 Views | Share:
How to install a punching mold?

How to install a punching mold - DGMF Mold Clamps Co., Ltd

1) Check whether the blanking holes of the mold and the blanking holes of the pad are consistent.

2) After the upper and lower dies are assembled, place them on the lower table surface. The reference plane of the punch and the reference plane of the mold must be parallel.

3) The lower mold should be completely fixed, and the upper mold should be fixed gently beforehand.

4) The slider on the punch presses for 20-30 trials. After confirming that the upper and lower dies are completely in a consistent state, tighten the upper dies.

5) The bite component of the punch and die of the punch is combined with the lower die stop of the die to adjust the height of the slider on the punch.

6) Use the test punch of the joint paper to confirm the cutting condition. If it is not uniform, check the installation status of the mold again. If the consistency is still not achieved, it is necessary to confirm the parallelism of the punch slider and the lower table of the punch.

7) Adjust the material feed length and feed time. (If a scrap cutter is attached, the length of the material can be checked by cutting the length of the scrap)